电信科学 ›› 2018, Vol. 34 ›› Issue (2): 12-22.doi: 10.11959/j.issn.1000-0801.2018003

• 研究与开发 • 上一篇    下一篇

一种交叠分层诱导的PLC自动路由算法设计

郑建宏1,2,3,陈鹤云1,周鹏光1,徐浩1   

  1. 1 重庆邮电大学通信与信息工程学院,重庆 400065
    2 教育部移动通信工程研究中心,重庆 400065
    3 重庆重邮信科通信技术有限公司,重庆 400065
  • 修回日期:2017-09-22 出版日期:2018-02-01 发布日期:2018-02-13
  • 作者简介:郑建宏(1961-),男,重庆邮电大学通信与信息工程学院教授、博士生导师,教育部移动通信工程研究中心主任,重庆重邮信科通信技术有限公司副总经理兼CTO,主要从事通信工程、信号与信息处理方面的工作。|陈鹤云(1992-),男,重庆邮电大学通信与信息工程学院硕士生,主要研究方向为嵌入式物联网。|周鹏光(1992-),男,重庆邮电大学通信与信息工程学院硕士生,主要研究方向为大规模MIMO。|徐浩(1992-),男,重庆邮电大学通信与信息工程学院硕士生,主要研究方向为 5G信道。
  • 基金资助:
    国家科技重大专项基金资助项目(2016ZX03002010-003)

Design of automatic routing algorithm based on overlapping hierarchical induction

Jianhong ZHENG1,2,3,Heyun CHEN1,Pengguang ZHOU1,Hao XU1   

  1. 1 School of Communication and Information Engineering,Chongqing University of Posts and Telecommunications,Chongqing 400065,China
    2 Ministry of Education Mobile Communication Engineering Research Center,Chongqing 400065,China
    3 Chongqing Post Information Technology Co.,Ltd.,Chongqing 400065,China
  • Revised:2017-09-22 Online:2018-02-01 Published:2018-02-13
  • Supported by:
    The National Science and Technology Major Project of China(2016ZX03002010-003)

摘要:

针对电力线信道中存在幅值波动很大且具有强时变特性脉冲噪声,严重影响电力载波网络通信性能的问题,分析了电力线网络拓扑结构以及电力线载波通信经典路由算法,并在此基础上提出了一种交叠分层诱导的自动路由算法(OHIA),重点验证了该算法的可行性,并给出了诱导因子传递过程、路由寻址过程以及基于预测的路由维护策略。通过NS-3仿真平台建立PLC节点模型,分别仿真蚁群算法和交叠分层诱导的PLC 自动路由算法。仿真结果表明,相比蚁群算法,交叠分层诱导的自动路由算法明显改善了强时变信道环境下第一次通信成功率,并在PLC大规模组网方面取得较大进步。

关键词: 电力载波通信, 组网路由, 分层诱导, 自动路由

Abstract:

Aiming at the problem of impulse noise with large amplitude fluctuation and strong time-varying characteristics,which seriously affected the communication performance of power carrier network,the power line network topology and the classical routing algorithm of power line carrier communication were analyzed,and on this basis,an algorithm of overlapping hierarchical induction algorithm (OHIA) was proposed,which proved the feasibility of the algorithm and gave the inductive factor transfer algorithm,route addressing process and forecast based route maintenance strategy.Through the NS-3 simulation platform to establish the PLC model,respectively,ant colony algorithm and overlapping layer induced PLC automatic routing algorithm were simulated.The simulation results show that compared with the ant colony algorithm,the proposed algorithm improves the success rate of the first communication in the strong time-varying channel environment,and makes great progress in the large-scale networking of PLC.

Key words: power line carrier communication, network routing, induced factor, automatic routing

中图分类号: 

No Suggested Reading articles found!