电信科学 ›› 2009, Vol. 25 ›› Issue (4): 56-61.doi: 10.3969/j.issn.1000-0801.2009.04.012

• 研究与开发 • 上一篇    下一篇

针对片上网络组播通信模型的设计与仿真

欧阳一鸣1,朱兵1,梁华国1,王伟1,2   

  1. 1 合肥工业大学计算机与信息学院 合肥 230009
    2 中国科学院计算技术研究所系统结构重点实验室 北京 100190
  • 出版日期:2009-04-15 发布日期:2017-08-11
  • 基金资助:
    国家自然科学基金重点项目;国家自然科学基金重点项目;国家“863”高技术研究发展计划基金资助项目;国家“863”高技术研究发展计划基金资助项目

Design and Simulation of a Multicast Communications Model for NoC

Yiming Ouyang1,Bing Zhu1,Huaguo Liang1,Wei Wang1,2   

  1. 1 School of Computer and Information,Hefei University of Technology,Hefei 230009,China
    2 Key Laboratory of Computer System and Architecture,Institute of Computing Technology, Chinese Academy of Sciences,Beijing 100190,China
  • Online:2009-04-15 Published:2017-08-11

摘要:

文章提出了一种针对片上网络的组播通信模型,能够为片上网络提供无死锁的通信。该模型能显著减少总通信量,增加通道利用率;在测试模式下,能有效节省测试时间。将该模型仿真应用到二维带环网格拓扑结构的片上网络中,试验结果表明,该模型较单播通信具有更小的平均传输延迟和更高的吞吐量。

关键词: 片上网络, 组播通信, 无死锁, 路由算法

Abstract:

A model of multicast communications is proposed for NoC(networks on chip)to provide communications to guarantee deadlock-free routing.Multicast model has the capability of reducing traffic remarkably,increasing utilization ratio of channels and decreasing testing time in test mode.Modeling of the multicast communications were simulated and applied on 2D Torus NoC.Experimental results demonstrate that our communications model has lower average communication latency and higher throughput than unicast communications.

Key words: networks on chip, multicast communication, deadlock-free, routing algorithm

No Suggested Reading articles found!